I loaded a stl..
Did repair
hollowed it out
chose any cubic photon printer
generated auto supports
export stl
go to anycupic photon slicer,
Load the exported stl and the model loads with non of of generated supports.
top of page
If you have any doubts about your printer or need a assistance or repair, please visit our support website.
If you have any doubts about your printer or need a assistance or repair, please visit our support website.
If you have any doubts about your printer or need a assistance or repair, please visit our support website.
Forum
bottom of page
You must have both objects selected and you can export it. Or you can select both and Merge it and export afterwards. 👍
when I do that and export I only get the supports exported and not the model. and I dont know how to have them both combined.. I will wait till more people use it. it is too clunky to use compared to the built in any cubic photon software.
Afterward you can export as STL de support as well
You must right click on the support and convert to stl first